Skip to content

Furnace Repair in Los Altos, CA

Serving Los Altos and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (669) 267-6986

The short answer

If your Los Altos furnace isn't heating, short-cycles, or smells or sounds wrong, FrostPeak AC Repair can diagnose and repair it at your home. Bay Area Air District rules do not force you to replace a working furnace, so repair is often a reasonable first step.

Los Altos winters are mild by most standards, but cold, damp nights still make a working furnace matter, especially in the early morning and evening. Many homes here rely on a gas forced-air furnace that sits idle most of the year and then gets asked to run every day once the rainy season arrives. FrostPeak AC Repair is based in San Jose, about 14 miles southeast, and we send technicians to Los Altos homes in the 94024 ZIP code and across Santa Clara County. This page covers what we check, which problems tend to show up, and how to think about repairing versus replacing under the Bay Area's current appliance rules.

Why Furnaces in Los Altos Act Up When the Weather Turns

The Santa Clara Valley has a Mediterranean climate: dry summers and mild, damp winters. That means a furnace can sit unused for months, collecting dust on the burners and flame sensor, and then run hard during the first cold stretch. Many of the calls we get come in that first week of steady heating.

Long idle periods also hide small problems. A thermostat battery that died in summer, a filter that was never changed after spring, or a condensate line that dried out and clogged often doesn't show up until the heat is needed. Damp winter air can add to the problem by corroding electrical connections and ignition parts over time.

Common Furnace Problems We Repair

Most furnace failures trace back to a short list of parts and conditions. Our technicians test each one instead of guessing, so you know what failed and why.

  • No heat at all, often from a failed igniter, tripped limit switch, or thermostat or wiring fault
  • Burners that light and then shut off, commonly a dirty or worn flame sensor
  • Short cycling, where the furnace turns on and off too often
  • Weak airflow from a blower motor, capacitor, clogged filter, or blocked return
  • Unusual noises such as squealing, banging, or rattling at startup
  • Error codes flashing on the control board
  • Condensate leaks or drain problems on high-efficiency furnaces
  • Pilot light or gas valve issues on older units

What Happens During a Furnace Repair Visit

We start by asking what you've noticed: when the problem began, whether it's constant or intermittent, and any smells or sounds. Then we check the thermostat, power, gas supply, filter, ignition sequence, flame quality, safety switches, blower, and venting.

Once we find the cause, we explain it in plain terms and tell you what the repair involves before any work begins. If a part has to be ordered, we'll tell you that up front and make the system as safe as possible in the meantime. We also check the heat exchanger and venting for signs of damage, because those affect safety, not just comfort.

Repair or Replace? What Bay Area Rules Mean for You

Under Bay Area Air District Rule 9-4, natural gas furnaces manufactured from 2029 must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when a furnace is replaced after that date. The rule does not require you to replace working equipment. It applies only when an existing furnace fails or is replaced.

For most Los Altos homeowners, that means a sound furnace with a fixable problem is usually worth repairing. If your furnace is older, needs frequent repairs, or has a cracked heat exchanger, we'll talk through whether a replacement or a heat pump makes more sense. The federal 25C tax credit for heat pumps is no longer available for new installations after 2025, but BayREN and local clean energy providers may offer incentives. Amounts and availability change by funding cycle, so we confirm the current offer before we mention it in a quote.

Simple Checks Before You Call

A few quick checks can save you a visit or help us diagnose faster:

  • Make sure the thermostat is set to heat and the temperature is above room temperature
  • Replace thermostat batteries if the display is blank or dim
  • Check that the furnace power switch is on and the breaker hasn't tripped
  • Look at the air filter and replace it if it's dirty
  • Confirm the furnace access panel is fully closed, since many units won't run otherwise

Serving Los Altos and Nearby Cities

In addition to Los Altos, we handle furnace repair in Mountain View, Sunnyvale, Cupertino, Santa Clara, and Saratoga. If you smell gas, leave the house and call your gas utility or 911 before calling any HVAC company. For everything else, from a furnace that won't start to one that just doesn't keep up, reach out and we'll schedule a visit.

More services in Los Altos

Related

What to expect

How a visit goes

  1. Find the cause first

    We test the system and pinpoint what's wrong before suggesting parts or replacement, so you aren't paying to guess.

  2. Explain it in plain language

    You'll hear what failed, why it likely happened, and what each option involves, without jargon or pressure.

  3. Give you real choices

    When repair and replacement are both reasonable, we lay out the tradeoffs and let you choose what fits your home and plans.

FAQ

Common questions

Do I have to replace my gas furnace because of the new Bay Area rules?

No. The Air District's appliance rules don't require replacing working equipment. They apply only when a furnace fails or is replaced, and the zero-NOx standard covers gas furnaces manufactured from 2029.

Why does my furnace smell like burning when I first turn it on?

A brief dusty or burning smell is common after months of non-use, because dust burns off the burners and heat exchanger. If it lasts more than a short while or smells like electrical burning or gas, turn the system off and call for service.

Why does my furnace start and then shut off after a few seconds?

A dirty or failing flame sensor is a frequent cause. The furnace can't confirm the burners lit, so it shuts the gas off for safety. Overheating from a clogged filter can also trip a limit switch.

Is it worth repairing an older furnace?

It depends on the furnace's condition, the repair needed, and how often it has failed. We'll give you an honest assessment and explain your options, including heat pumps, before you decide.

Can I still get a federal tax credit for a heat pump?

The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025, so it isn't available for new installations now. Check BayREN and your local clean energy provider for current incentives.

Do you serve all of Los Altos?

Yes. We serve homes throughout Los Altos in the 94024 ZIP code, along with nearby Mountain View, Sunnyvale, Cupertino, Santa Clara, and Saratoga.

Tell us what your system is doing

Whether your AC is blowing warm air, your furnace won't start, or you're weighing a heat pump, contact FrostPeak AC Repair. We'll start with a diagnosis and walk you through your options.

Call (669) 267-6986 Request Service