The short answer
If your furnace or heat pump is blowing cool air, cycling on and off, making new noises, or not responding to the thermostat, it likely needs repair. FrostPeak AC Repair diagnoses the cause, explains your options and the cost before any work starts, and fixes the problem with your approval.
A broken heater in San Jose isn't usually the emergency it would be in a colder state, but it still matters. Winters in the Santa Clara Valley are mild and damp, and a cold, clammy house on a December night is uncomfortable, especially for kids, older relatives, or anyone working from home. FrostPeak AC Repair fixes gas furnaces, heat pumps, and the controls and ductwork connected to them for homeowners in San Jose and nearby cities. This page covers the warning signs to watch for, what we check, how we think about repairing versus replacing, what affects the cost, and what to expect when we come out.
Signs your heating system needs repair
Heating systems rarely fail all at once. Most give warning signs for weeks before they stop working. Because we only run the heat for part of the year here, many problems show up on the first cold night of fall, when a system that sat idle all summer has to work again.
A light dusty smell the first time you turn on the heat each season is normal. A smell that lingers, or anything that smells like rotten eggs, is not.
- The system runs but blows cool or lukewarm air
- Some rooms stay warm while others stay cold
- The furnace or heat pump turns on and off every few minutes
- New noises, such as banging, scraping, squealing, or a loud rumble at startup
- A burning smell that doesn't fade after the first few minutes of use
- Any smell of gas (leave the house and call your gas utility first)
- Higher energy bills without a change in how you use the heat
- A heat pump's outdoor unit that stays iced over
- A thermostat that doesn't seem to control anything
What we check on a heating repair call
We start with the problem you describe, but we don't stop at the first thing we find. A failed part is often the result of something else. For example, a clogged filter can make a furnace overheat. Replacing the part without fixing the cause usually means another breakdown. Depending on your equipment, we look at:
If we find a safety concern, such as a cracked heat exchanger or a venting problem that could let combustion gases into the home, we explain it plainly and show you what we found.
- Thermostat settings, wiring, and batteries
- The air filter and airflow through return and supply vents
- The igniter, flame sensor, and burners on gas furnaces
- Gas pressure and venting, including the flue and draft inducer motor
- Heat exchanger condition, looking for cracks or corrosion
- The blower motor, capacitor, and blower wheel
- Limit switches, pressure switches, and other safety controls
- Control board error codes
- On heat pumps: refrigerant pressures, the reversing valve, defrost controls, and the outdoor coil and fan
- Reachable duct connections, for leaks or disconnected runs
Repair or replace?
Most heating calls end in a repair. Igniters, flame sensors, capacitors, and switches wear out, and replacing them is usually the sensible choice. Replacement comes up when a repair is large compared to the value of the system, when a major part like the heat exchanger has failed, or when the same system keeps breaking down. We'll lay out both paths and let you decide.
Bay Area Air District rules do not require you to replace working equipment. They apply only when an existing furnace or water heater fails or is replaced. Under Rule 9-4, natural gas furnaces manufactured from 2029 on must meet a zero-NOx emission standard, which in practice points homeowners toward heat pumps when a furnace is replaced after that date. If your furnace is aging, that's worth factoring into a repair decision now.
If you're also thinking about your water heater, the zero-NOx date for small water heaters under Rule 9-6 was set for 2027, and the Air District Board has been considering amendments in November 2026 that could delay it. Check the current rule before you plan that replacement.
On incentives: the federal 25C tax credit covered qualifying heat pumps placed in service before December 31, 2025, so it isn't available for new installations now. BayREN and your local clean energy provider may offer heat pump and electrification incentives, but amounts and availability change with each funding cycle. We confirm the current offer before including it in any quote.
What affects the cost of a heating repair
We can't give a price until we know what's wrong, but these are the main factors that drive the cost of a heating repair:
We explain the repair and its cost before starting any work, and we don't start until you approve it.
- Which part failed, and whether it's a common part or specific to your brand and model
- Whether the part is available locally or has to be ordered
- How hard the equipment is to reach, such as in an attic, crawlspace, closet, or garage
- The type of system: gas furnace, heat pump, or dual-fuel
- Whether there's one problem or several related ones
- Whether a heat pump needs refrigerant work
- Timing, such as after-hours or weekend visits
How a heating repair visit works
Here's what to expect from the time you contact us:
It helps to clear the area around the furnace or indoor unit and to know where your filter is. If you suspect a gas leak, don't wait for us. Leave the house and call your gas utility or 911.
- Tell us what's happening: the symptoms, when they started, and the type of system if you know it.
- We schedule a time window and let you know when the technician is on the way.
- The technician talks with you, inspects the system, and diagnoses the problem.
- You get a clear explanation of what's wrong and your options, with the cost of each, before any work begins.
- With your approval, we make the repair and run the system through a full heating cycle to confirm it works.
- We point out anything else we noticed, like a dirty filter or a loose duct, so you can plan for it.
Heating Repair by city
- Heating Repair in Campbell
- Heating Repair in Los Gatos
- Heating Repair in Monte Sereno
- Heating Repair in Saratoga
- Heating Repair in Santa Clara
- Heating Repair in Cupertino
- Heating Repair in Milpitas
- Heating Repair in Sunnyvale
- Heating Repair in Los Altos
- Heating Repair in Mountain View
- Heating Repair in Morgan Hill
- Heating Repair in Fremont

