Skip to content

Furnace Repair in Monte Sereno, CA

Serving Monte Sereno and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (669) 267-6986

The short answer

FrostPeak AC Repair diagnoses and repairs gas furnaces in Monte Sereno homes, from ignition and flame sensor problems to blower and pressure switch failures. Bay Area Air District rules do not require replacing a working furnace, so a sound unit can usually be repaired and kept in service.

Monte Sereno winters are mild by most standards, but cold, damp nights from late fall through early spring still keep a furnace busy. When yours blows cool air, shuts off right after lighting, or won't start, FrostPeak AC Repair sends a technician from our San Jose base, about 7 miles east, to find the cause and fix it. We focus on getting your existing furnace running safely. We explain what we found in plain terms so you can decide what comes next without pressure.

Common Furnace Problems in Monte Sereno Homes

The Santa Clara Valley has a Mediterranean climate with dry summers and mild, damp winters. Many furnaces here sit idle for months, then run hard on the first cold nights. That stop-and-start pattern tends to expose problems that built up while the system was off. Dust settles on the flame sensor, igniters weaken, filters clog, and condensate drains on high-efficiency units dry out or plug.

These are the symptoms that most often lead homeowners to call for furnace repair:

  • The furnace runs but blows cool or lukewarm air
  • Burners light, then shut off after a few seconds
  • No heat at all, even though the thermostat is calling for it
  • The blower won't shut off, or won't turn on
  • Banging, squealing, or rattling when the system starts
  • A burning smell that lasts well past the first few minutes of the season
  • Water pooling around a high-efficiency furnace

What Happens During a Furnace Repair Visit

We start with the basics, because a surprising number of no-heat calls trace back to something simple. We check thermostat settings and batteries, the furnace power switch, the gas supply, the filter, and the access panel safety switch. From there we watch the furnace go through its startup sequence. We read any error codes and test the igniter, flame sensor, pressure switch, limit switch, inducer motor, and blower motor.

Once we know the cause, we explain it to you, describe the repair, and get your approval before doing the work. If we find signs of a venting problem or a damaged heat exchanger that could affect carbon monoxide safety, we will tell you directly. If the furnace is not safe to run, we will shut it down and walk you through your options.

Repair or Replace? What Bay Area Rules Mean for Your Furnace

Under Bay Area Air District Rule 9-4, natural gas furnaces manufactured from 2029 must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when they replace a furnace after that date. The Air District rules do not require you to replace working equipment, though. They apply only when an existing furnace fails or is replaced. If your furnace can be repaired safely, you can keep using it.

When a furnace is older, needs a major part, or has been failing repeatedly, we will give you a plain comparison of repairing it versus replacing it, including a heat pump. Keep in mind that the federal 25C tax credit only covered qualifying heat pumps placed in service before December 31, 2025, so it does not apply to new installations now. Bay Area homeowners can still check BayREN and their local clean energy provider for current heat pump and electrification incentives. Amounts and availability change by funding cycle, so we confirm the current offer before quoting it.

Simple Steps to Keep Your Furnace Ready

A few habits help your furnace start reliably when the first cold snap arrives, and they can save you a service call:

  • Replace or clean the filter before heating season and check it every month or two while the furnace is in use
  • Turn the heat on for a test run in early fall, before you actually need it
  • Keep storage, laundry, and boxes clear of the furnace and its vents
  • Make sure supply registers and return grilles aren't blocked by furniture or rugs
  • Replace thermostat batteries once a year
  • If you ever smell gas, leave the house and contact your gas utility from outside before calling us

Serving Monte Sereno and Nearby Santa Clara County Communities

Monte Sereno is a short drive from our San Jose base, and we also handle furnace repair in nearby Los Gatos, Saratoga, Campbell, Cupertino, and Santa Clara. In many South Bay homes, the furnace and the central air conditioner share the same blower and ductwork. Inland and southern parts of the valley run noticeably hotter in summer than areas near the Bay, so a failing blower motor or control board can affect your cooling as well as your heat. When we repair a furnace, we keep that shared equipment in mind, so the fix works for both seasons.

More services in Monte Sereno

Related

What to expect

How a visit goes

  1. Find the cause first

    We test the system and pinpoint what's wrong before suggesting parts or replacement, so you aren't paying to guess.

  2. Explain it in plain language

    You'll hear what failed, why it likely happened, and what each option involves, without jargon or pressure.

  3. Give you real choices

    When repair and replacement are both reasonable, we lay out the tradeoffs and let you choose what fits your home and plans.

FAQ

Common questions

Why does my furnace light and then shut off after a few seconds?

This is often caused by a dirty flame sensor that can't confirm the burners are lit. It can also come from a clogged filter, a venting restriction, or a failing pressure switch. A technician can test each one and find the actual cause.

Do Bay Area rules require me to replace my gas furnace?

No. The Bay Area Air District appliance rules do not require replacing working equipment. They apply only when an existing furnace fails or is replaced. Furnaces manufactured from 2029 must meet a zero-NOx standard.

Is it worth repairing an older furnace?

It depends on the condition of the furnace, the cost of the part, and how often it has needed repairs. We explain what we found and lay out both options so you can make the call.

Can I still get the federal tax credit for a heat pump?

No. The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025, and it is not available for new installations. You can check BayREN and your local clean energy provider for current incentives.

What should I check before calling for furnace repair?

Confirm the thermostat is set to heat and has working batteries. Make sure the furnace power switch is on and the access panel is closed. Replace the filter if it's dirty. If none of that helps, schedule a repair visit.

What should I do if I smell gas near my furnace?

Leave the house right away and contact your gas utility from outside. Don't switch lights or appliances on or off. Once the utility says it's safe, we can inspect and repair the furnace.

Tell us what your system is doing

Whether your AC is blowing warm air, your furnace won't start, or you're weighing a heat pump, contact FrostPeak AC Repair. We'll start with a diagnosis and walk you through your options.

Call (669) 267-6986 Request Service