The short answer
FrostPeak AC Repair fixes gas furnaces in Santa Clara homes, including ignition failures, short cycling, blower problems and safety shutdowns. Most furnace problems can be repaired, and Bay Area Air District rules do not require you to replace a furnace that still works.
Santa Clara winters are mild, but the cold, damp nights from late fall through winter are when a furnace that sat idle all summer tends to act up. FrostPeak AC Repair sends technicians from our San Jose base, about 9 miles southeast, to homes across Santa Clara in ZIP codes 95050, 95051, 95053 and 95054. We find out why your furnace isn't heating, fix what can be fixed, and tell you plainly when a repair no longer makes sense.
Common Furnace Problems in Santa Clara Homes
Because heating runs only part of the year here, many problems come from a system that sat unused for months, not from heavy wear. Dust settles on the flame sensor, filters get forgotten, and small issues show up the first cold morning you turn on the heat. These are the calls we see most often:
- Furnace runs but blows cool air, often from a dirty flame sensor or an ignition problem
- Burners light, then shut off after a few seconds
- Blower runs nonstop or won't start at all
- Short cycling, where the furnace turns on and off every few minutes
- A burning-dust smell that doesn't fade after the first few hours of use
- Banging, rattling or squealing from the cabinet or ducts
- Thermostat calls for heat but nothing happens
- Error codes flashing on the control board
What Happens During a Repair Visit
Our technician starts by asking what you've noticed and when it started. Then we check the thermostat, power and gas supply, filter, igniter and flame sensor, safety switches, blower motor and venting. A furnace that shuts itself off is often doing so for a safety reason, so we look for the cause instead of just resetting it.
Before any work begins, we explain what we found and what the repair involves. If a part has to be ordered, we tell you up front. We also look for signs of a cracked heat exchanger or poor venting, because those affect your household's safety, not just your comfort.
If you smell gas, don't wait for a repair appointment. Leave the house and call your gas utility from outside.
Repair or Replace? What Bay Area Rules Mean for You
Most furnace problems are repairable. Igniters, flame sensors, pressure switches, capacitors and blower motors are routine fixes. Replacement becomes a real conversation when the heat exchanger is damaged, parts are no longer available, or the furnace keeps needing major repairs.
Bay Area Air District rules are part of that decision. Under Rule 9-4, natural gas furnaces manufactured from 2029 must meet a zero-NOx emission standard, which in practice points homeowners toward heat pumps when they replace a furnace after that date. The rules do not require you to replace working equipment; they apply only when an existing furnace fails or is replaced. Repairing your current furnace is still a reasonable choice, and we'll give you an honest read on how much life it has left.
Thinking About a Heat Pump Instead?
The Santa Clara Valley has dry summers and mild, damp winters, a climate where one heat pump can handle both heating and cooling. If your furnace is near the end of its life, it can help to compare a repair with a heat pump now, before a breakdown forces a rushed decision.
On incentives: the federal Energy Efficient Home Improvement Credit (25C) covered qualifying heat pumps placed in service before December 31, 2025, and it is not available for new installations. Bay Area homeowners can still check BayREN and their local clean energy provider for heat pump and electrification incentives. Amounts and availability change by funding cycle, so we confirm the current offer before including it in a quote.
If you're also planning to replace a gas water heater, note that the zero-NOx date for small water heaters under Rule 9-6 was set for 2027, and the Air District Board is considering amendments in November 2026 that could delay it. Check the current rule before you plan that project.
Quick Checks Before You Call
A few simple checks can save you a visit. If none of them work, contact us and describe what you're seeing. We also serve Sunnyvale, Cupertino, Campbell, Milpitas and Mountain View.
- Make sure the thermostat is set to Heat with the setpoint above room temperature, and replace its batteries if it uses them
- Confirm the furnace's service switch, which often looks like a light switch near the unit, is on and the breaker hasn't tripped
- Replace a dirty filter, since a clogged one can cause overheating and shutdowns
- Check that the furnace door panel is fully closed; a safety switch keeps the unit off if it isn't
- Keep boxes, paint and cleaning supplies away from furnaces in garages, closets and attics
More services in Santa Clara
- AC Repair in Santa Clara
- Heating Repair in Santa Clara
- Heat Pump Installation in Santa Clara
- AC Installation in Santa Clara

