The short answer
FrostPeak AC Repair diagnoses and fixes gas furnaces and heat pumps in Cupertino homes, with technicians coming from our San Jose base about 10 miles away. You don't have to replace a working furnace under Bay Area Air District rules. Gas furnaces manufactured from 2029 must meet a zero-NOx standard, so we help you weigh a repair against a future heat pump.
Cupertino winters are mild, but the damp, chilly nights from late fall through early spring still put your furnace or heat pump to work. When the heat stops coming on, blows cool air, or starts making a new noise, FrostPeak AC Repair sends a technician from our San Jose base, about 10 miles east, to find the cause and fix it. We repair gas furnaces, heat pumps, thermostats, and the ductwork that connects them in homes throughout the 95014 ZIP code and the rest of Santa Clara County. Below is what typically goes wrong, what a repair visit covers, and how current Bay Area rules affect your choice between repairing and replacing.
Why Cupertino Heating Systems Act Up
The Santa Clara Valley has a Mediterranean climate, with dry summers and mild, damp winters. Many Cupertino furnaces sit unused for months and then get switched on during the first cold snap. Over the summer, dust settles on the burners, flame sensor, and blower. When the furnace starts again, that dust can cause a burning smell, short run cycles, or no heat at all. Heat pumps wear differently. The same unit cools in summer and heats in winter, so wear builds up year-round.
- The furnace lights briefly, then shuts off. A dirty flame sensor is a common cause.
- The blower runs, but the air from the vents is cool.
- The heat pump runs constantly or frosts over on damp mornings.
- You hear clicking, banging, squealing, or rattling at startup.
- Some rooms or floors stay noticeably colder than others.
- The thermostat doesn't respond or keeps losing its settings.
What a Heating Repair Visit Covers
Your technician starts by asking what you've noticed and when it began. Then they check the system from the thermostat to the vents. On a gas furnace, that means the igniter, flame sensor, gas valve, pressure switch, inducer motor, blower, and filter. On a heat pump, it means refrigerant pressures, the reversing valve, the defrost controls, and the outdoor coil. We also check for safety problems such as a cracked heat exchanger or a blocked flue. Before any work begins, we explain what we found.
If a part has to be ordered, we tell you what it is and whether the system can safely run in the meantime.
Repair or Replace? What the Air District Rules Mean for You
Most heating problems can be repaired. New regulations don't force you to replace a furnace that still works. The Bay Area Air District appliance rules apply only when an existing furnace or water heater fails or is replaced.
Planning ahead still makes sense. Under Air District Rule 9-4, natural gas furnaces manufactured from 2029 must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when they replace a furnace after that date. If an older furnace needs a major repair, such as a new heat exchanger or control board, compare that cost with where your system is likely headed in the next few years.
The federal Energy Efficient Home Improvement Credit covered qualifying heat pumps placed in service before December 31, 2025. It isn't available for new installations now. Cupertino homeowners can check BayREN and their local clean energy provider for current heat pump and electrification incentives. Amounts and availability change with each funding cycle, so we confirm the current offer before we quote it.
Quick Checks Before You Call
A few simple checks can sometimes get the heat back on, or at least narrow down the problem. If you smell gas, skip these steps. Leave the house and call your gas utility from outside, then call us.
- Make sure the thermostat is set to Heat and the setpoint is above room temperature. Replace its batteries if it uses them.
- Check the circuit breaker and the furnace power switch, which often looks like a light switch near the unit.
- Replace a dirty filter. A clogged filter can make a furnace overheat and shut itself off.
- Make sure the furnace door panel is fully closed. Many units won't run if it's loose.
- If you have a heat pump, clear leaves and debris from around the outdoor unit.
Heating Repair in Cupertino and Nearby Cities
Cupertino is about 10 miles west of our base in San Jose. We also handle heating repair in nearby Saratoga, Los Altos, Sunnyvale, Santa Clara, and Campbell. If you own a second home or rental property in the area, the same team can help with that system too.
More services in Cupertino
- AC Repair in Cupertino
- Heat Pump Installation in Cupertino
- AC Installation in Cupertino
- Furnace Repair in Cupertino

